User Manual

Attach the lens to the camera tightly so that both

mounting surfaces are in complete contact.

The mounting method differs depending on the lens

mounts. Refer to the operation manual for the respective

camera for the detailed information.

If the rod interferes with the lens body or drive unit when

mounting the lens, remove the rod and then mount the

lens.

Secure the lens holder on the lens support using the

screw supplied with the lens support.

3 Secure the attachment holder to a different lens

support from the lens support mentioned in step 2,

and fit the attachment holder into the attachment

holder contact plate (

㉒

in figure on page 2) at the

rear of the lens.

4 Fix the lens support to the rods using lens support

xing screws.

2 HOW TO MOUNT

2-1. MOUNT THE LENS ON THE CAMERA

For PL mount, read the following instructions before mounting the lens.

The PL mount supports /i communication, so make sure that the camera is set to “/i”. Do not mount the lens if

the camera is set to a mount communication mode other than /i. Doing so could result in malfunction.

Before mounting the lens on the camera, make sure that the power of camera and the power of supply

equipment are turned off.

2 HOW TO MOUNT

Lens Support

Screw supplied with the

Lens Support

Attachment

Holder

Rods

(Φ19)

Lens Support Fixing Screws