User Manual

1 Fit the hood on the front of the lens barrel.

2 Align the index on the hood and lens barrel.

3 Tighten the hood lock knob.

2-3. TURN IT ON

Turn on the camera and power supply equipment on, and the power of the lens will be supplied.

2-2. MOUNT THE HOOD ON THE LENS

The lens cap is attached to the lens at the factory. Please remove the lens cap before mounting the

hood.

2 HOW TO MOUNT

5 When the lens is mounted, connect the cable from

the drive unit to a power supply equipment such as

camera or external power supply.

Or if the camera can be powered from the PL mount,

connect the cable from the drive unit to the connector

below the lens mount.

* Connect the cable so that the connector of the cable

aligns with the connector of the lens.

* Bundle up the cable with the tie cable as needed.

NOTE

Rated voltage: 12 VDC

Normal operation range: 10 to 17 VDC

If a battery or adapter is used, the output voltage may be higher than the rated voltage depending on the manufacturers

and therefore the above voltages must be observed strictly. If a voltage outside the normal operation range is used, the

drive unit may be damaged.

Hood

Hood Lock Knob

Index

Lens

Barrel