User Manual
Table Of Contents
- Important Usage Instructions
- Highlights of the XC10
- Table of Contents
- 1. Introduction
- 2. Preparations
- 3. Recording
- Recording Video and Taking Photos
- Video Configuration: Movie Format (MXF/MP4), Resolution (4K/HD), Frame Rate and Bit Rate
- Shooting Modes
- Automatic Gain and ISO Limits
- Exposure
- Light Metering Mode
- White Balance
- Using Looks
- Zooming
- Adjusting the Focus
- Image Stabilizer
- Onscreen Markers and Zebra Patterns
- Setting the Time Code
- User Bit
- Recording Audio
- Using Commercially Available Microphones
- Audio Scenes (Built-in Microphone)
- Audio Recording Level
- Wind Screen (Built-in Microphone)
- Microphone Attenuator (Built-in Microphone)
- Audio Equalizer (Built-in Microphone)
- Microphone Directionality (Built-in Microphone)
- Microphone Attenuator (External Microphone)
- Low Cut Filter (External Microphone)
- Switching the Input
- Audio Limiter
- Audio Compressor
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Recording GPS Information (Geotagging)
- Slow & Fast Motion Mode
- Pre-recording Mode
- Interval Recording Mode
- Self Timer
- Orientation Detection
- Using an Optional Speedlite Flash
- 4. Customization
- 5. Playback
- Playback
- Playing Back Recordings
- Changing the Index Screen
- Onscreen Icons and Displays during Playback
- Playback Controls during Clip Playback
- Playback Controls during Photo Playback
- Adjusting the Volume
- Displaying Clip Information
- Playing an HD-sized Clip from a 4K Clip
- Capturing Photos from 4K Clips (4K Frame Grab) and HD Clips
- Magnifying Photos during Playback
- Deleting Recordings
- Playback
- 6. External Connections
- 7. Wi-Fi Functions
- 8. Additional Information
19
Charging the Battery Pack
Menus
Table of Contents Index
7 Charging will start when the camcorder is turned off.
• If the camcorder was on, the green POWER/CHG indicator will
go out when you turn off the camcorder. After a moment, the
POWER/CHG indicator will turn on in red (battery pack
charging). The red POWER/CHG indicator will go out when the
battery pack is fully charged.
• If the indicator flashes, refer to
Troubleshooting
(A 142).
8 Disconnect the compact power adapter in the order shown
in the illustration.
To remove the battery pack
Open the battery compartment cover and slide the battery
release latch in the direction of the arrow so the battery pack
springs out. Remove the battery pack and close the cover.
POWER/CHG
(battery pack charging)
indicator
햲
햳
햴
햵
햲
햳
햴
Battery
release latch