Owner's Manual

56
a: Fully Automatic Wireless Flash Shooting
5
Set the flash mode to <a>.
Press the <E> button of the
<S> cross keys of the master unit.
Turn <9> to select <Q>, then
press <8>.
The slave unit is set automatically to
<a> during shooting via the
control from the master unit.
Check that the firing group control is
set to <8>.
6
Check the transmission status
and charge status.
Check that the <D> lamp is lit in
green.
When the slave flash is ready, the AF-
assist beam emitter blinks at approx.
1-second intervals.
Check that the <Q> slave flash-ready
icon is lit on the master unit’s LCD
panel (<G> is not displayed).
For the master unit’s LCD panel
illumination, see page 54.
Check that the master unit’s flash-
ready lamp is lit.
7
Check the performance.
Press the master unit’s test flash button.
X The slave unit fires. If it does not fire,
check that it is placed within the
transmission range (p.46).
8
Take the picture.
Set the camera and take the picture
in the same way as with normal flash
shooting.
Slave flash ready
Firing group control