Owner's Manual

This section describes wireless (multiple flash) shooting using manual

flash. You can shoot with a different flash output setting for each slave

unit (firing group). Configure all the settings on the master unit.

Set the flash mode to <q>.

Press the <E> button of the

<S> cross keys of the master unit.

Turn <9> to select <R>, then

press <8>.

Set firing group control.

Press <8>.

Turn <9> to select the firing group

control symbol, then press <8>.

Turn <9> to select the group to be

fired, then press <8>.

<T> : Set all groups to the same

flash output

<U> : Set the flash output of A

and B

<V> : Set the flash output of A, B,

and C

Set the flash output.

Turn <9> to select the firing group

symbol, then press <8>.

Turn <9> to set the flash output,

then press <8>.

With <5> and <7>, repeat

steps 3 to set the flash output for all

groups.

Take the picture.

X Each group fires at the set flash ratio.

: Wireless Multiple Flash Shooting with Manual Output

Firing group control

When <8> is set, set A, B, or C as the firing group for the slave units

(p.59). The flash will not fire if it is set to D or E.