Owner's Manual

Wireless Settings

To perform flash shooting using the optical transmission wireless slave

function, configure the settings as follows.

Set to <:x>.

Operate and set the flash you want to

set as the slave unit.

Press the <

I> button of the <S>

cross keys.

Turn <9> to select <:x>,

then press <8>.

To avoid interference with optical transmission wireless flash systems

used by other photographers, you can change the transmission

channel. Set the same channel for both the master unit and slave

unit.

Set a channel.

Press <8>.

Turn <9> to select the channel

symbol, then press <8>.

Wireless Settings

Slave Unit Setting

Turn transmission wireless sensor (p.10) of the slave unit toward the

master, using the bounce function (p.28).

When shooting indoors, since the transmission signal is reflected off the

walls, operation may be possible even with slightly imprecise positioning.

Transmission Channel Setting

To perform normal flash shooting, select <F> to clear the wireless

(slave) settings.