Owner's Manual

87
>: Setting Personal Functions
P. F n- 0 5 : ] (AF-assist beam emission method)
You can select AF-assist beam emission method.
0: J (Small series of flashes fired by flash)
AF-assist beam, which uses a small series of flashes, is emitted
(p.22).
1: K (Infrared)
Infrared AF-assist beam aiming at the center AF point is emitted.
Position the subject in the center of the viewfinder and focus. The
effective range is approx. 0.7 - 8 m/2.3 - 26.2 ft.
P. F n- 0 6 : + (Quick flash)
You can set whether or not to fire the flash when the flash-ready lamp is lit
in green (before the flash is fully charged) to shorten the charge waiting
time. Quick flash also functions during continuous shooting.
0: ON (Enabled)
1: OFF (Disabled)
When 1 is set, manually select the center AF point. When an AF point
other than the center AF point is selected, focusing with the AF-assist
beam is not possible (AF-assist beam is not emitted).
When the color filter is attached (p.37), the AF-assist beam, which uses
a series of small flashes, is not emitted. If AF-assist beam is required, set
the value to 1.
When Quick flash is fired during continuous shooting, underexposure may
occur since the flash output decreases.