User Manual

• WPA2-PSK (AES) is applied as the default security setting. However, you can change the security
setting and the password using IJ Network Tool.
If you change the access point mode setting of the machine, also change the access point setting of
your device.
Connecting Device to Machine
Specify the device settings and connect the device to the machine following the procedure below.
Note
• Before connecting a device, we recommend you check the access point name (SSID) and the
password for the access point mode.
To check the access point name (SSID) and the password, print out the network setting information of
the machine.
Printing Network Settings
1.
Turn on wireless communication on your device.
Enable "Wi-Fi" on your device's "Setting" menu.
For more on turning on wireless communication, see your device's instruction manual.
2.
Select "XXXXXX-G3000series" ("XXXXXX" represents last six digits of machine's MAC
address.) from list displayed on device.
Note
• If "XXXXXX-G3000series" does not appear on the list, access point mode is not enabled.
See Enabling Access Point Mode to enable access point mode.
3.
Enter password.
The machine serial number is specified as the password at the time of purchase.
The machine serial number is printed on the sticker attached on the machine rear. It consists of 9
alphanumeric characters (four alphabets followed by five numbers).
Note
•
To check machine's serial number, print out the network setting information.
Printing Network Settings
Your device is connected to the machine.
Printing/Scanning with Access Point Mode
Connect a device and the machine and start printing/scanning.
481