User Manual

— 18—
ITEM
LABEL
DESCRIPTION
SEE PAGE:
1.
Up cursor
Navigates and changes settings in the OSD
25
2.
Enter
Changes settings in the OSD
3.
Power
Turns the projector On or Off
20
4.
Right cursor
Navigates and changes settings in the OSD
25
5.
Volume +
Increase volume
24
6.
Volume -
Decrease volume
7.
Mute
Mutes the built-in speaker
8.
Freeze
Freeze/unfreezes the on-screen picture
9.
Source
Detects the input device
10.
Auto
Auto adjustment for frequency, tracking, size, position (RGB only)
11.
Keystone top
Corrects image-trapezoid (wider top) effect
24
12.
Keystone bottom
Corrects image trapezoid (wider bottom) effect
13.
Down cursor
Navigates and changes settings in the OSD
25
14.
Left cursor
Navigates and changes settings in the OSD
15.
Menu
Opens the OSD
Remote Control Operating Range
The remote control uses infrared transmission to control the projector. It is not necessary to point
the remote directly at the projector. Provided you are not holding the remote perpendicular to the
sides or the rear of the projector, the remote will function well within a radius of about 7 meters (23
feet) and 15 degrees above or below the projector level. If the projector does not respond to the
remote control, move a little closer.
Projector and Remote Control Buttons
The projector can be operated using the remote control or the buttons on the top of the projector. All
operations can be carried out with the remote control; however, the buttons on the projector are
limited in use.