User Manual

71
a: Fully Automatic Wireless Flash Photography
During radio transmission wireless shooting, the master unit’s LCD
panel illuminates or turns off according to the charge status of the
master unit and slave units (firing groups).
The master unit’s LCD panel illuminates if the master unit and slave units
are not fully charged. When the master unit and slave units are fully
charged, the LCD panel illumination will turn off after approx. 12 sec.
When the charge of the master unit and slave units becomes
insufficient as you take pictures, the master unit’s LCD panel will be
illuminated again.
When you need more flash output or you
want to perform lighting more easily, you
can increase the number of slave units
and fire them as a single flash.
To add slave units, perform the same
procedure as “Autoflash Shooting Using
One Slave Unit” (p.68). Set the firing
group to A, B, or C (p.73). The flash will
not fire if it is set to D or E.
When the number of slave units is increased or master flash firing is set
to ON, automatic control is performed to fire all flashes at the same
flash output and to ensure that the total flash output results in the
standard exposure.
LCD Panel Illumination
Autoflash Photography Using Multiple Slave Units
If the master unit or any of the slave units (firing group) are not fully charged,
<G> will be displayed on the master unit’s LCD panel. Make sure to
take the picture after checking either that the <G> icon is not
displayed on the LCD panel or the LCD panel is not illuminated.