Guide for Windows

CONTENTS

GLOSSARY

INDEX

Chapter 2

Installing ScanGear CS-S 4.3

Chapter 2

Installing ScanGear CS-S 4.3

Before You Install

Before you install ScanGear CS-S, make sure the following items:

• Is a SCSI card mounted properly to your computer ? (Refer to the

Getting Started Guide on details.)

• Is a SCSI interface cable connected properly ? (Refer to the Getting

Started Guide on details.)

• Is an AC adapter connected to the CanoScan FB1200S scanner ? The

CanoScan FB1200S has to be powered on before the computer is

turned on. (Refer to the Getting Started Guide on details.)

Installing ScanGear CS-S

Note: If ScanGear CS-S has already been installed according to the

instructions in the Getting Started Guide, there is no need to

perform the following procedures.

The following procedure describes how to install ScanGear CS-S in Windows

95, Windows 98 and Windows NT 4.0.

Use the following steps to install ScanGear CS-S.

Note: You must be logged on as an administrator in Windows NT

4.0.

To install ScanGear CS-S software:

1. Place the CanoScan Setup Utility CD-ROM in the computer drive.