User Guide

Change Default Settings
Specify settings used for sending faxes. The selected settings are used as the default settings when scanning
documents. Changing Default Settings(P. 139)
Resolution
200 x 100 dpi (Normal)
200 x 200 dpi (Fine)
200 x 200 dpi (Photo)
200 x 400 dpi (Superne)
Density
Nine Le
vels
2-Sided Original
*1
Off
Book Type
Calendar T
ype
Sharpness
Seven Levels
Register Unit Name
Register the name of a company or person. Registering the Fax Number and Unit Name(P. 108)
The r
egistered name is sent as sender information to the destination.
TX Terminal ID(P. 501)
ECM TX
Enable or disable error correction mode (ECM). ECM checks for fax data errors and corrects them. To reduce
err
ors on received faxes, see
ECM RX(P. 502) .
Off
On
● ECM must be enabled on both the machine and the other fax de
vice because error checks are
performed on both the sending and receiving devices.
● Even when ECM is enabled, errors may occur due to telephone line conditions.
● It may take a longer time than usual to process data when ECM is enabled because the error checks
and corrections are performed while the data is transmitted.
<Menu> <Fax Settings> <TX Function Settings> <ECM TX> <On>
Set Pause Time
For example, when you make calls by dialing "0 - (pause) - (telephone number)", 0 is dialed rst and then a fe
w
seconds later, the telephone number. When sending faxes overseas, you need to specify destinations by dialing
"(international access code) - (country code) - (area code) - (fax number)" but consecutive numbers that are
Setting Menu List
499