User Manual

2
23
Preparations
Preparing the Backup Battery
The camera uses a CR2025 lithium button battery as a backup battery to ensure that the camera’s settings are
not lost when no other power source is connected to the camera. To install the supplied lithium button battery,
you will need to remove any extension modules attached to the camera*.
* The camera is shipped with the battery adapter for V-mount batteries attached.
Removing an Extension Module
The following procedure is explained using the battery adapter for V-mount batteries supplied with the camera
as example.
1 Use the supplied hex wrench to remove the four fixation screws from the top and bottom of the
battery adapter.
2 Slide the battery adapter release switch in the direction of the arrow.
• The locking lever will pop out.
3 Pull the locking lever all the way up and pull the top of the battery adapter away from the camera.
4 Lift up the battery adapter and remove it from the camera.
5 Push down the locking lever until it clicks.
햲
햴
햵
햳
햲