User's Manual
Table Of Contents
- Table of Contents
- Introduction
- Preparations
- Shooting Video and Shooting Functions
- Shooting Video
- Video Configuration: System Frequency, Frame Rate and Resolution
- Setting the Camera Mode
- Adjusting Main Camera Functions with the Joystick
- Adjusting the Aperture
- Gain
- Shutter Speed
- ND Filter
- White Balance
- Adjusting the Focus
- Aspect Markers
- Infrared Mode
- Using the Optional RC-V100 Remote Controller
- Customization
- External Connections
- Additional Information
Date and Time Settings
20
Date and Time Settings
You will need to set the date and time of the camera before you can start using it. When the camera's
clock is not set, the [Date/Time] screen will appear automatically with the first field selected (month or
day, depending on the country/region of purchase).
1 Push the joystick up/down to change the month/day then press SET (press the joystick
itself) to move to the next field.
• To move to the next field you can also push the joystick right.
2 Change the rest of the fields in the same way.
3 Select [Set] and then press SET to start the clock and close the screen.
NOTES
• With the following settings, you can change the time zone, date and time also after the initial setup.
You can also change the date format and clock format (12 or 24 hours).
- [Other Functions] > [Time Zone]
- [Other Functions] > [Set Clock] > [Date/Time] and [Date Format]
• While a recording command is being output to an external recorder (A 63), you cannot change the
date/time or time zone.
• When the built-in rechargeable lithium battery is exhausted, the date and time setting may be lost. In
such case, recharge the built-in lithium battery (A 75) and set the time zone, date and time again.
Similarly, if the camera's settings have been reset, you will need to perform the setup again.
• The time indicated on the screen is approximate.
• You can display the date/time on the shooting screen with the [Other Functions] > [Custom
Display] > [Date/Time] setting.