User's Manual
Table Of Contents
- Table of Contents
- Introduction
- Preparations
- Shooting Video and Shooting Functions
- Shooting Video
- Video Configuration: System Frequency, Frame Rate and Resolution
- Setting the Camera Mode
- Adjusting Main Camera Functions with the Joystick
- Adjusting the Aperture
- Gain
- Shutter Speed
- ND Filter
- White Balance
- Adjusting the Focus
- Aspect Markers
- Infrared Mode
- Using the Optional RC-V100 Remote Controller
- Customization
- External Connections
- Additional Information
Aspect Markers
50
Aspect Markers
The camera offers the following onscreen markers that indicate commonly-used aspect ratios: 4:3,
4:3 Super 35mm (j only), 1.66:1, 1.85:1 and 2.39:1. Use the aspect markers to make sure the
subject is correctly framed and within the appropriate safe area.
1 Open the [Activate] submenu to activate the aspect
markers.
[Other Functions] > [Aspect Marker] > [Activate]
2 Select [On] and then press SET.
• To check the aspect marker on the shooting screen, press
the MENU button to close the menu. If necessary, press
the MENU button again to return to the menu and change
the aspect marker's settings.
To change the aspect marker's settings
1 Open the [Color] submenu to select the aspect
marker's color.
[Other Functions] > [Aspect Marker] > [Color]
2 Select [Black], [Gray] or [White] and then press SET.
3 Open the [Ratio] submenu to select the aspect ratio.
[Other Functions] > [Aspect Marker] > [Ratio]
4 Select the desired aspect ratio and then press SET.
NOTES
• If you set an assignable button to [Aspect Marker] (A 54), you can press the button to turn the
aspect marker on and off.
Aspect marker 2.39:1, gray (default) Aspect marker 4:3, white
[Other Functions]
[Aspect Marker]
[Activate]
[Off]
[Other Functions]
[Aspect Marker]
[Color] ..... [Gray]
[Ratio] ..... [2.39:1]