Owner's Manual

FCC/IC Notice
Model: PC2329 (including
Wireless Module Models
ES200, FCC
ID:AZD230
I
IC:498J-230 and Model WM500, FCC
ID:AZD500
I
IC:498J-500)
This device
complies
with Part
15
of
FCC Rules and
Industry
Canada's licence-exempt
RSSs. Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause
undesired operation
of
this device.
This
tran~mitter
mu~t
not
be
Go-loGated
or
operated
in
conjunction
with
~ny
other
antenna
or
transmitter.
Model: PC2329 (including Wireless Module Model
ES200, FCC ID:AZD230
I
IC:498J-230)
The available scientific evidence does not show that any health problems are
associated with using low power wireless devices. There is no proof, however, that
these low power wireless devices are absolutely safe. Low power Wireless devices
emit low levels
of
radio frequency energy (RF) in the microwave range while being
used. Whereas high levels
of
RF can produce health effects (by heating tissue),
exposure
of
low-level RF that does not produce heating effects causes no known
adverse health effects. Many studies
of
low-level RF exposures have not found any
biological effects. Some studies have suggested that some biological effects might
occur, but such findings have not been confirmed
by
additional research. This model
has been tested and found to comply with
FCC/IC
radiation exposure limits set forth
I
for an
uncontrolled environment and meets the
FCC
radio frequency (RF) Exposure
Guidelines and RSS-1 02
of
the IC
radio frequency (RF) Exposure rules.
'--------'
To
ensure proper operation
of
this product, use
of
genuine Canon
accessories is recommended.
• Interface Cable IFC-600PCU
HDMI cable
(camera end: Type D): Use a commercially
available cable
no
longer than 2.5 m.
For CA,
USA
only
I
Included
lithium battery contains Perchlorate Material - special handling
may apply.
See www.dtsc.ca.govlhazardouswastelperchloratel for details.
I
Some logos
for
technical standards the camera has met can be viewed on the screen
by choosing MENU
•
lfTl
tab
• [Certification Logo Display].
89