User Manual

User Maintenance
52AC-04W
The settings about adjustment of the machine including print position correction
for each paper source and print quality impr
ovement are listed with short
descriptions. You can specify those settings when the machine is oine. Default
settings are marked with a dagger (
).
Asterisks (
*
)
● Settings mark
ed with an asterisk (
*
) may not be displayed depending on the options you ar
e using, or other
setting items.
Adj. Print Position(P. 374)
Recovery Printing(P. 375)
Initialize Counter(P. 375)
Check Paper Size(P. 376)
Corr Consc Prnt Void(P. 377)
Substitute Size(P. 377)
Auto Detect Ppr Type(P. 377)
Short Edge Fd. Prty.(P. 378)
Special Image Mode(P. 378)
Sp. Transfer Mode(P. 379)
Wrinkle Correction(P. 379)
Sp. Fixing Mode 4(P. 379)
Improve Toner Fixing(P. 380)
Clr/B&W Switch Mode(P. 380)
Charged Rlr Cleaning(P. 381)
Corr. Drum Line(P. 381)
Special Density Mode(P. 381)
SD Card Maintenance(P. 382)
Special Print Mode(P. 382)
Special Print Mode E(P. 388)
Update Firmware(P. 389)
First Calibration(P. 389)
Paper Feed Method(P. 390)
Adjust Standby Temp(P. 390)
Show Job List(P. 391)
Paper Delivery Adj.(P. 391)
Rdc Hvy 3 Clr Msmtch(P. 392)
Corr. Color Mismatch(P. 392)
Correct B&W Density(P. 392)
POP Printing Speed(P. 393)
POP Prnt Color Corr.(P. 393)
Toner Warning Mode(P. 394)
Auto POP Calibration(P. 394)
Import/Export Set.(P. 395)
Calibration Freq.(P. 396)
Notify to Clean(P. 396)
Clean. Notif. Timing(P. 396)
Toner Check Timing(P. 396)
Spec Tnr Chk Timing(P. 397)
Drum Check Timing(P. 397)
Spec Drum Chk Timing(P. 397)
Action When Tnr. Out(P. 398)
Rdc Bndg for Low Spd(P. 398)
Reduce Margin Stain(P. 399)
Control Condensation(P. 399)
Adj. Print Position
You can adjust the print position for each paper sour
ce.
Adjusting Print Position(P. 513)
Offset Y (2-Sided)
You can adjust the vertical print position for printing on the rst page (front side) in 2-sided printing mode. The
print position on the second page (back side) follo
ws the settings for the paper source available when the
printing is started.
-5.0 to 0.0
to +5.0 (mm)
Setting Menu List
374