Owner's Manual

Table Of Contents
17
Preparation for Web Services
Start EOS Utility on the computer, log in to CANON iMAGE GATEWAY,
then specify the camera’s settings to enable access to Web services.
For details, refer to the EOS Utility Instruction Manual. For how to
obtain the EOS Utility Instruction Manual, refer to the Camera
Instruction Manual.
The general procedure for sending images to a Web service is as
follows.
1 Install EOS Utility on a computer.
If you have already installed it, proceed to step 2.
2 Access Canon Web site from the computer and sign up
as a CANON iMAGE GATEWAY member (free of charge).
If you are already a member, proceed to step 3.
3 Connect the camera and computer via Wi-Fi (p.77).
You can also configure the settings by connecting the camera and
computer with an interface cable (sold separately) instead of via
Wi-Fi.
4 Start EOS Utility on the computer, log in to CANON
iMAGE GATEWAY, then specify the camera’s settings to
enable access to Web services.
For details, refer to the EOS Utility Instruction Manual.
Specifying Settings to Use Web Services