Owner's Manual

Responding to Error Messages
146
 Did you hold down the access point’s WPS (Wi-Fi Protected
Setup) button for the specified period of time?
 Hold down the WPS button for the period of time specified in the
access point’s instruction manual.

Are you trying to establish a connection near the access point?
 Try establishing the connection when both devices are within reach
of each other.

Connection is in progress by other access points in Pushbutton
Connection mode (PBC mode) of WPS (Wi-Fi Protected Setup).
 Wait a while before trying to establish the connection, or try to
establish a connection in PIN code connection mode (PIN mode)
(p.114).
 A problem other than error code number 11 to 69 occurred.
 Turn off and on the camera’s power switch.
 Has the procedure to establish a Wi-Fi connection between
cameras been performed on the other camera as well?
 Perform the procedure to establish a Wi-Fi connection between
cameras on the other camera as well.
 Even with cameras whose connection settings have been
registered with each other, perform the reconnection procedure on
both cameras when reconnecting them after terminating the first
Wi-Fi connection.
 Is Wi-Fi connection being attempted by multiple cameras?
 The camera can be connected to only one camera at a time via
Wi-Fi. Confirm that no other camera is attempting to establish a
connection nearby and retry connection.
68: Cannot connect to wireless LAN terminal. Retry from
the beginning.
69: Multiple wireless LAN terminals have been found.
Cannot connect. Retry from the beginning.
91: Other error
101: Could not establish connection