User's Manual
Table Of Contents
- Highlights of the XF405 / XF400
- Table of Contents
- Introduction
- Preparations
- Recording
- Recording Video and Photos
- Video Configuration: Resolution, Bit Rate and Frame Rate
- Dual Recording and Relay Recording
- Slow & Fast Motion Recording
- Adjusting the Focus
- Zooming
- Image Stabilization
- Automatic Gain Control (AGC) Limit
- Shooting Modes
- Adjusting the Exposure
- ND Filter
- White Balance
- Using Looks
- Setting the Time Code
- Setting the User Bit
- Recording Audio
- Using Headphones
- Color Bars/Audio Reference Signal
- Pre-Recording
- Infrared Recording
- Using the Optional RC-V100 Remote Controller
- Using the Optional GP-E2 GPS Receiver
- Customization
- Playback
- External Connections
- Network Functions
- Additional Information
Video Output Configuration
118
Video Output Configuration by Terminal (External Recording Only)
Refer to the following table for the video output configuration from each terminal when the camcorder is set to
external recording-only mode (A 119).
1
[3 Recording Setup] > [Internal/External Rec] setting.
2
[3 Recording Setup] > [External Rec Video Config.] setting.
Internal/external recording
1
Video configuration for external
recording
2
m SDI OUT terminal HDMI OUT terminal
m
[ø External Rec Only (SDI)]
[1920x1080 59.94P
YCC422 10bit]
1920x1080
YCbCr 4:2:2 10 bit
—
[1920x1080 29.97P
YCC422 10bit]
1920x1080
YCbCr 4:2:2 10 bit
[ù External Rec Only (HDMI)]
[3840x2160 59.94P
YCC420 8bit]
—
3840x2160
YCbCr 4:2:0 8 bit
[3840x2160 29.97P
YCC422 8bit]
3840x2160
YCbCr 4:2:2 8 bit
[1920x1080 59.94P
YCC422 10bit]
1920x1080
YCbCr 4:2:2 10 bit
[1920x1080 29.97P
YCC422 10bit]
1920x1080
YCbCr 4:2:2 10 bit