User Manual

Setting the User Bit

The user bit display can be selected from the date or the time of recording, or an identification code

consisting of 8 characters in the hexadecimal system. There are sixteen possible characters: the

numbers 0 to 9 and the letters A to F. When you record a scene, the user bit will be recorded with it.

The user bit is also output from the HD/SD-SDI terminal (o only) or HDMI OUT terminal.

1 Open the user bit [Setting] screen.

[FUNC.] > [MENU] > > [User Bit Type] > [ Setting]

• To set the time for the user bit, select [ Time] instead; to set the date for the user bit, select

[ Date]. Then, touch [

X]. The rest of the procedure is not necessary.

• The user bit setting screen will appear with the orange selection frame on the leftmost digit.

• To reset the user bit to [00 00 00 00], select [Reset].

• Touch [Cancel] to close the screen without setting the user bit.

2 Touch the digit you want to change and then touch [Í] or [Î] to change it as necessary.

3 Touch another digit you want to change.

4 Change the rest of the digits in the same way.

5 Touch [OK] and then touch [X].

NOTES

• When playing back MP4 movies, the user bit embedded in the signal output from the HD/SD-SDI

terminal (o only) and HDMI OUT terminal will have a value of 0 and cannot be changed.

Operating modes: