User's Manual
Table Of Contents
- Contents
- Setting Up
- Main Functions
- Preparations Required Before Use
- Preventing Unauthorized Access
- Setting Up Using the Setup Guide
- Setting the Date/Time
- Setting Up the Network Environment
- Installing Drivers
- Configuring Scan Settings
- Basic Operations
- Copying
- Printing
- Scanning
- Linking with Mobile Devices
- Managing the Machine
- Setting Access Privileges
- Configuring the Network Security Settings
- Restricting the Machine's Functions
- Managing the Machine from a Computer (Remote UI)
- Updating the Firmware
- Initializing Settings
- Setting Menu List
- Maintenance
- Troubleshooting
- Appendix
- SIL OPEN FONT LICENSE
● Select <Off>. If you select <DHCP> when these services ar
e unavailable, the machine will waste time
and communications resources searching the network for these services.
3
Check that <Auto IP> is set to <On>.
● If <Off> is selected, change the setting to <On>.
4
Select <Apply>.
● IP addr
esses assigned via DHCP override the address obtained via Auto IP.
Manually entering an IP address
1
Congure a setting to disable auto-acquisition.
● Select <Auto Acquir
e>, and set both <Select Protocol> and <Auto IP> to <Off>.
2
Select <Manually Acquire>.
3
Specify the IP address, subnet mask, and gateway address (or default gateway).
● Enter these values in each screen, and select <Apply>.
● On how to enter text, see
Entering Text(P. 84) .
Checking whether the settings are correct
● Mak
e sure that the Remote UI screen can be displayed with your computer (
Starting Remote
UI(P
. 198) ). If a computer is not available, you can check the connection by using the operation panel (
Testing the Network Connection(P. 29) ).
When you have changed the IP addr
ess after installing the printer driver
● When the MFNP port is used, the connection is maintained as long as the machine and the computer belong
to the same subnet; therefore, you do not need to add a new port. When the standard TCP/IP port is used,
you need to add a new port.
Conguring Printer Ports
(P. 39)
*
If you do not know which port is used, see
Checking the Printer Port(P. 345) .
Testing the Network Connection
1
Select <Menu> in the Home screen.
Home Screen(P. 78)
2
Select <Network Settings>.
● If the scr
een for entering a PIN appears, enter the correct PIN.
Setting the System Manager PIN(P. 165)
3
Select <TCP/IP Settings> <IPv4 Settings> <PING Command>.
4
Enter the IPv4 address of another device on the network, and select <Apply>.
➠ If a pr
oper connection has been established, <Received response from host.> is displayed.
Setting Up
29