User's Manual
72
• Keep the printer near the access point, without objects between them.
• Conrm that the password is correct, and try connecting again.
• Conrm that the access point channel is between 1 – 11. Instead of auto channel
assignment, it is advisable to specify a channel in this range manually. For instructions
on checking or adjusting the settings, refer to the access point user manual.
• If the access point lters communication by MAC or IP addresses, on the access point,
register the printer information shown when you check the settings (=
53).
For instructions on checking or adjusting the settings, refer to the access point user
manual.
• In WEP networks without DHCP, set the IP address manually (=
53).
Cannot connect via Wi-Fi
• Try restarting SELPHY. If a connection still cannot be established, check the settings
of the access point or other device for the Wi-Fi connection.
• If WPS connection is not possible, try connecting by using [Search for an access
point] (=
58) or by selecting [Manual Settings] when connecting via an access point
(=
58).
Can connect to access point, but cannot print
• Remove any inserted memory cards or USB ash drives.
• Printing is not possible when the printer is already printing a job from another device,
or when the printer is connected to a camera.
• Conrm that the camera, smartphone, or computer you are printing from is connected
to the same access point as SELPHY.
• Check the access point password and try to connect again (=
52).
• If a message is displayed after you enter the correct password and press the <o>
button (=
59), conrm that DHCP server functionality is enabled on the access
point, and make sure connection settings on SELPHY such as the IP address are
correct (=
53).
• Check the access point settings to conrm that communication between the devices is
allowed.