User Manual

Preparing the Camcorder

NOTES

• If you set an assignable button to [OLED Setup] or [Viewfinder Setup] (A 107), you can press the button to

open the respective submenu.

• You can also press the DISP. button and hold it pressed for about 3 seconds to turn the OLED [Luminance]

setting on and off.

Adjusting the Color Balance of the OLED Screen

As times passes, the color balance of the OLED screen may change

gradually. You can adjust the color balance of the OLED screen to

compensate for this change.

1 Open the [Color Balance] submenu.

[£ OLED/VF Setup] > [OLED Setup] > [Color Balance]

2 Select [R-B Simult. Adjust.] and then press the joystick.

3 Change the setting to adjust the red and blue levels simultaneously and

then press the joystick.

4 If necessary, select [R Fine Tuning] or [B Fine Tuning] to further adjust

only the red or blue level.

5 Adjust the setting as necessary and then press the joystick.

Using a Tripod

The camcorder is shipped with the TB-1 Tripod Base for tripods with 0.95 cm (3/8 in.)

screws. You can mount the camcorder on a tripod but do not use tripods with mounting

screws longer than 5.5 mm (0.2 in.) as this may cause damage to the camcorder.

Using a Tripod with 0.64 cm (1/4 in.) Mounting

Screws

To use a tripod with 0.64 cm (1/4 in.) mounting screws, first

attach the supplied tripod adapter base to the camcorder and

then attach the tripod to the adapter base.

1 Remove the original TB-1 Tripod Base from the camcorder.

• Remove the 4 screws and then remove the base.

2 Attach the supplied tripod adapter base for 0.64 cm (1/4 in.)

tripods.

• Firmly screw in the 4 screws.

3 Attach the tripod.

• Firmly screw in the tripod screw.

[£ OLED/VF Setup]

[OLED Setup]

[Color Balance]

[R-B Simult. Adjust: ±0]

[R Fine Tuning: ±0]

[B Fine Tuning: ±0]

5.5 mm