User Manual

Zooming

When an EF Cinema lens compatible with zoom adjustment (A 207) is attached to the camcorder, you can

operate the zoom using the camcorder or the optional RC-V100 Remote Controller (A 106).

Required settings on EF Cinema lenses

To operate the zoom from the camcorder when using a compatible EF Cinema lens, you will need to enable

automatic adjustment using the controls on the lens. Required settings vary depending on the lens. Refer to the

following table and the instruction manual of the lens used.

1 Enable automatic adjustment on the lens.

2 Open the grip unit's zoom [Setting] submenu.

[v Camera Setup] > [Camera Grip Zoom] > [Setting]

3 Select [On] and then press the joystick.

4 Open the grip unit's zoom [Speed] submenu.

[v Camera Setup] > [Camera Grip Zoom] > [Speed]

5 Select the desired zoom speed and then press the joystick.

• You can select one of 16 constant speeds (1 is the slowest, 16 is

the fastest).

6 Push the grip unit's joystick up/down to zoom in/out.

NOTES

• When an optional RC-V100 Remote Controller is connected to the

camcorder, you can adjust the zoom with the remote controller's

ZOOM dial.

• When using slower zoom speeds, it may take time for the lens to

start zooming.

Lens Part used on the lens Setting for automatic adjustment

CN7x17 KAS S/E1

CN20x50 IAS H/E1

Zoom operation change-over knob SERVO

CN-E18-80mm T4.4 L IS KAS S,

CN-E70-200mm T4.4 L IS KAS S

Zoom change-over switch SERVO

[~ Camera Setup]

[Camera Grip Zoom]

[Setting]

[Off]

[~ Camera Setup]

[Camera Grip Zoom]

[Speed]

[8]