User's Manual

Table Of Contents

For the module installation to host systems, please follow the instruction below.

1. Insert the FPC or FFC into the connector on the board. The contact of the connector is the

bottom contact (board side). Please refer to the circuit diagram for the pin arrangement of the

connector.

2. Align the two holes on the board with the two holes on the main unit side.

3. Tighten the board and the main body together using two screws. Use M2 screws for the screws.

Note: This module is certified as limited modular approval as it does not have its own power

supply regulator, therefore regulated 3.3V must be supplied by a host device using voltage

regulator, e.g. TLV62084ADSG (Vout 3.3V+-0.12V/Iout >= 0.25A) or equivalent.

This is a user manual for host product manufacturers to use when integrating the module in a host product.

The device shall be installed as described above and is designed to use

an integrated antenna. Do not modify the antenna or any other part of

the module. Any modifications will invalidate the modular

certifications and require new approvals for the host system.

PAGE 1
This is a user manual for host product manufacturers to use when integrating the module in a host product. For the module installation to host systems, please follow the instruction below. 1. Insert the FPC or FFC into the connector on the board. The contact of the connector is the bottom contact (board side). Please refer to the circuit diagram for the pin arrangement of the connector. 2. Align the two holes on the board with the two holes on the main unit side. 3.
PAGE 2
This device complies with below part 15 of the FCC Rules. Part 15 Subpart C The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules) listed on the grant (FCC Part 15.249), and the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant of certification. The final host product still requires Part 15 Subpart B compliance testing with the modular transmitter installed.
PAGE 3
FCC/ISED Notice for model: NCA01A The end product must be labeled “Contains FCC ID: AZD247” and “Contains ISED Certification Number: 498J-247” Following statement must be included in the user manual of host device. FCC/ISED NOTICE Model: ZWAVE Module Model NCA01A, FCC ID: AZD247/IC:498J-247) This device complies with part 15 of FCC Rules and Industry Canada’s licence-exempt RSSs.