Help Guide

62
Index
Appendix
Errors and Warnings
Troubleshooting
Settings
Playback
Shooting
Setup and Basics
Learning About the Camera
Accessories
Wireless Features
Wireless Features/Accessories
Safety FE
● When there is a risk of overexposure, the camera automatically
adjusts the ISO speed for ash shots to reduce washed-out highlights
and shoot at optimal exposure. However, you can deactivate automatic
adjustment of the ISO speed by choosing [ 1] tab → [Flash control]
→ [Safety FE] → [Disable].
Adjusting the Flash Exposure Compensation
● You can also congure the ash exposure compensation by
choosing [ 1] tab → [Flash control] → [Built-in ash settings] →
[ exp. comp.].
● You can also access the [Built-in ash settings] screen as follows.
- When the ash is up, press the
button and immediately press the
button.
- Press the
button, and then touch [ ].
Shooting with FE Lock
● FE: Flash Exposure
● The metering range is shown by a circle in the center of the screen
when FE is locked.
● [
] blinks when standard exposure is not possible, even if you press
the button to re the ash. Enable FE lock by pressing the
button when subjects are within ash range.
Changing the Flash Timing
● [1st curtain] is used whenever the shutter speed is 1/100 or faster,
even if you select [2nd curtain].
Changing the Flash Metering Mode
● When using [Average], adjust ash exposure compensation to suit the
shooting conditions.
● Mount the camera on a tripod or take other measures to keep it
still and prevent camera shake. In this case, also disable image
stabilization (
=
62).
● Even after the ash res, ensure that the main subject does not move
until the shutter sound is nished playing.
Other Settings
Changing the IS Mode Settings
● The following [IS mode] items are available.
On
Corrects camera movement or camera shake using
built-in image stabilization performed by the lens.
Off Deactivates image stabilization.
● Image stabilization is only applied at the moment of shooting in
[ ]
mode, regardless of the lens IS setting.
● If image stabilization cannot prevent camera shake, mount the camera
on a tripod or take other measures to hold it still. Additionally, you
should set [IS mode] to [Off] when using a tripod or other means to
secure the camera.
● [IS mode] is not displayed for lenses other than EF-M lenses. Use the
image stabilization switch on the lens instead.