Owner's Manual

Error Codes
Error No. If there is a problem with the camera, an
error message appears. Follow the on-
screen instructions.
To recover from the error screen, turn the
power switch <OFF> and <ON>, or
remove and reinstall the battery.
If error 02 (Card problem) is displayed,
remove and reinstall the card or format the
,
Countermeasures card. This may resolve the problem.
If the same error keeps appearing, there may be a problem. Write
down the error code and consult your nearest Canon Service
Center.
l'g.No.
..•• ; ...•...•..•...••.•••.•••••••...........................
.. ",<".
Error Message &Sol~t.i()I'
..' ..... ·····• •••..................•..•••• 1 •••• : •••• , ••..
• •••••••••••••• /<
".
:' '.
Communications between the camera and lens is faulty. Clean the
lens contacts.
01
~ Clean the electrical contacts on the camera and lens, use a Canon
lens, or have the camera or lens checked or repaired. (p.13, 16)
There is a problem with the card. Replace the card.
02
-+ Remove and install the card again, replace the card, or format the
card. (p.29, 43)
Cannot save images because the card is full. Replace the card.
04
-+ Replace the card, erase unnecessary images, or format the card.
(p.29,
142,43)
Self Cleaning Sensor Unit malfunction. Consult with Canon
Service Center.
06
-+ Operate the power switch or have the camera checked or repaired.
(p.27)
10,20,
Shooting is not possible. Turn the power switch to <OFF> and
30,40,
<ON> again or re-install the battery.
50,60,
~ Operate the power switch, remove and install the battery again, use
70, 80
a Canon lens, or have the camera checked or repaired. (p.27,26)
209
I