Owner's Manual

Error No.
Countermeasures
Error Codes
If there is a problem with the camera, an
error message appears. Follow the on-
screen instructions.
To recover from the error screen, turn the
power switch <OFF> and <ON>, or
remove and reinstall the battery.
If error 02 (Card problem) is displayed,
remove and reinstall the card or format the
card. This
may resolve the problem.
If the same error keeps appearing, there may be a problem. Write
down the error code and consult your nearest Canon Service Center.
No.
Error Message & Solution
Communications between the camera and lens is faulty. Clean the
lens contacts.
Err 01
~ Clean the electrical contacts on the camera and lens, use a Canon
lens, or have the camera or lens checked
or repaired. (p.13, 16)
There is a problem with the card. Replace the card.
Err 02
~ Remove and install the card again, replace the card, or format the
card. (p.29, 43)
Cannot save images because the card is full. Replace the card.
Err 04
~ Replace the card, erase unnecessary images, or format the card.
(p.29, 144, 43)
The built-in flash's auto pop-up was obstructed. Turn the power
Err 05
switch to <OFF> and <ON> again.
~ Operate the power switch. (p.27)
Self Cleaning Sensor Unit malfunction. Consult with Canon
Service Center.
Err 06
~ Operate the power switch or have the camera checked or repaired.
(p.27)
Shooting is not possible. Turn the power switch to <OFF> and
Err 99
<ON> again or re-install the battery.
~ Operate the power switch, remove and install the battery again, use
a Canon lens, or have the camera checked
or repaired. (p.27,26)
201
•