User's Manual
Table Of Contents
- Contents
- Setting Up
- Main Functions
- Preparations Required Before Use
- Preventing Unauthorized Access
- Setting Up Using the Setup Guide
- Setting the Date/Time
- Setting Up the Network Environment
- Installing Drivers
- Configuring Initial Settings for Fax Functions
- Configuring Scan Settings
- Basic Operations
- Parts and Their Functions
- Turning ON the Machine
- Using the Operation Panel
- Placing Originals
- Loading Paper
- Customizing the Display
- Changing the Default Settings for Functions
- Setting Sounds
- Entering Quiet Mode
- Entering Sleep Mode
- Registering Destinations
- Copying
- Faxing
- Printing
- Scanning
- Linking with Mobile Devices
- Managing the Machine
- Setting Access Privileges
- Configuring the Network Security Settings
- Restricting the Machine's Functions
- Managing the Machine from a Computer (Remote UI)
- Registering Destinations from Remote UI
- Saving/Loading Address Book from Remote UI
- Importing/Exporting Address Book Data with the Supplied Software
- Updating the Firmware
- Initializing Settings
- Setting Menu List
- Maintenance
- Troubleshooting
- Appendix
- SIL OPEN FONT LICENSE
● It may tak
e a longer time than usual to process data when ECM is enabled because the error checks
and corrections are performed while the data is transmitted.
<Menu> <Fax Settings> <TX Function Settings> <ECM TX> Select <Off> or <On>
<Set Pause Time>
For example, when you make calls by dialing "0 - (pause) - (telephone number)", 0 is dialed rst and then a fe
w
seconds later, the telephone number. When sending faxes overseas, you need to specify destinations by dialing
"(international access code) - (country code) - (area code) - (fax number)" but consecutive numbers that are
input without pauses may not be recognized correctly. In this case, try adding a pause after the international
access code or the fax number. If the code or the number is still not recognized correctly, change the duration
of the pause. For instructions on how to enter a pause, see step 4 on
Basic Operations for Sending
Fax
es(P. 196) .
1 to 2
to 15 (sec.)
<Menu> <Fax Settings> <TX Function Settings> <Set Pause Time> Specify the duration of
pause <Apply>
<Auto Redial>
Specify settings for Auto Redial, a function that automatically redials the fax number after several minutes if the
rst attempt fails because the line is busy
. You can specify how many times the machine redials and the interval
between redials.
<Off>
<On>
<Number of Times to Redial>
1 to 2 to 10 (times)
<Redial Interval>
2 to 99 (min.)
<Redial When Err
or Occurs>
<Off>
<On>
<Menu> <Fax Settings> <TX Function Settings> <Auto Redial> <On> Specify the settings
<Apply>
Setting Menu List
393