Owner's Manual
Table Of Contents
- Instruction Manual
- Highlights of the XF705
- Table of Contents
- Introduction
- Preparations
- Recording
- Recording Video
- Video Configuration: Video Format, System Frequency, Frame Rate, Resolution and Bit Rate
- Changing Main Functions with the FUNC Button
- Shutter Speed
- Gain
- ND Filter
- Aperture
- Gamma Curve and Main Color Settings
- White Balance
- Zooming
- Using Optional Conversion Lenses
- Adjusting the Focus
- Image Stabilization
- Onscreen Markers and Zebra Patterns
- Setting the Time Code
- Setting the User Bit
- Synchronizing with an External Device
- Recording Audio
- Audio Settings and Recorded Audio Channels
- Connecting an External Microphone or External Audio Input Source to the Camcorder
- Setting the Audio Input Type for the INPUT 1/INPUT 2 Terminals
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Waveform Monitor
- Adding Marks to Clips while Recording
- Using Metadata
- Recording GPS Information (Geotagging)
- Reviewing a Recording
- Special Recording Modes
- Infrared Recording
- Customization
- Playback
- External Connections
- Network Functions
- Photos
- Additional Information
Reviewing a Recording
112
Reviewing a Recording
If you set an assignable button to [Review Recording] in advance, you can review all or part of the last clip
recorded even with the camcorder set to mode.
1 Set an assignable button to [Review Recording] in advance (A 117).
2To set the review length, select [Review Recording].
> [
B
% System Setup] > [Review Recording]
3 Select the desired option and then press SET.
4 After you finish recording a clip, press the assignable button.
• The last clip that was recorded is played back for the selected duration. [
Ð
REVIEW] appears at the top of
the screen.
• While the clip is reviewed, there will be no sound from the built-in speaker but the audio will be output from
the × (headphone) terminal, HDMI OUT terminal and SDI terminal.
• You can use the joystick to jump back/forward within the clip (A 135).
• Press the CANCEL button to stop reviewing the clip and return the camcorder to record standby mode.
• After the clip finishes playing back, the camcorder returns to record standby mode.
Options
[Entire Clip]: Allows you to review the entire clip.
[Last 4 sec]: Allows you to review just the last 4 seconds of the clip.
NOTES
NOTES
• If the camcorder switched SD cards during a recording, the camcorder will play back the clip on the card most
recently recorded on.
Operating modes: