Owner's Manual
Table Of Contents
- Instruction Manual
- Highlights of the XF705
- Table of Contents
- Introduction
- Preparations
- Recording
- Recording Video
- Video Configuration: Video Format, System Frequency, Frame Rate, Resolution and Bit Rate
- Changing Main Functions with the FUNC Button
- Shutter Speed
- Gain
- ND Filter
- Aperture
- Gamma Curve and Main Color Settings
- White Balance
- Zooming
- Using Optional Conversion Lenses
- Adjusting the Focus
- Image Stabilization
- Onscreen Markers and Zebra Patterns
- Setting the Time Code
- Setting the User Bit
- Synchronizing with an External Device
- Recording Audio
- Audio Settings and Recorded Audio Channels
- Connecting an External Microphone or External Audio Input Source to the Camcorder
- Setting the Audio Input Type for the INPUT 1/INPUT 2 Terminals
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Waveform Monitor
- Adding Marks to Clips while Recording
- Using Metadata
- Recording GPS Information (Geotagging)
- Reviewing a Recording
- Special Recording Modes
- Infrared Recording
- Customization
- Playback
- External Connections
- Network Functions
- Photos
- Additional Information
Special Recording Modes
114
4Press the REC button again to stop recording.
• The clip is recorded at the selected frame rate.
• The tally lamps go out and [SLOW STBY] appears at the top of the screen.
5 When you have finished recording, turn off the special recording mode.
• Repeat steps 1 and 2 selecting [Normal Recording] instead.
NOTES
NOTES
• Slow motion recording cannot be used together with pre-recording.
• When slow motion recording is activated, the [PQ] and [HLG] options in the custom picture file ([Gamma] and
[Preset]) and their corresponding LUTs will not be available.
• The shooting frame rate cannot be changed while recording.
• The time code signal will not be output from the SDI terminal, HDMI OUT terminal or TIME CODE terminal.
• If the video format or system frequency is changed, slow motion recording will be canceled and the shooting
frame rate will be reset to its default value.
• About the time code when slow motion recording is activated:
- The time code mode can be set to [Regen.], or to [Preset] with [Rec Run] running mode.
- If the time code running mode was set to [Free Run], the time code running mode will be changed
automatically to [Rec Run] when slow motion recording is activated.
- When the special recording mode is turned off, the time code running mode will return to its previous setting.
Pre-recording
When pre-recording is activated, the camcorder starts recording continuously into a temporary memory (approx.
3 seconds) so when you press the REC button, the clip will contain also a few seconds of video and audio
recorded before you pressed the button.
1 Select [Recording Mode].
> [
Æ
! Recording/Media Setup] > [Recording Mode]
2 Select [Pre-Recording] and then press SET.
• [PRE REC STBY] appears at the top of the screen.
3Press the REC button to begin recording.
• The tally lamps illuminate.
• [PRE REC STBY] changes to [
Ü
PRE REC] while recording.
4Press the REC button again to stop recording.
• The clip is recorded. The recorded clip will include a few seconds of video and audio recorded before the
REC button was pressed.
• The tally lamps go out and [PRE REC STBY] appears at the top of the screen.
5 When you have finished recording, turn off the special recording mode.
• Repeat steps 1 and 2 selecting [Normal Recording] instead.
NOTES
NOTES
• Pre-recording cannot be used together with slow motion recording.
• If the video format or system frequency is changed, pre-recording will be canceled.