Owner's Manual
Table Of Contents
- Instruction Manual
- Highlights of the XF705
- Table of Contents
- Introduction
- Preparations
- Recording
- Recording Video
- Video Configuration: Video Format, System Frequency, Frame Rate, Resolution and Bit Rate
- Changing Main Functions with the FUNC Button
- Shutter Speed
- Gain
- ND Filter
- Aperture
- Gamma Curve and Main Color Settings
- White Balance
- Zooming
- Using Optional Conversion Lenses
- Adjusting the Focus
- Image Stabilization
- Onscreen Markers and Zebra Patterns
- Setting the Time Code
- Setting the User Bit
- Synchronizing with an External Device
- Recording Audio
- Audio Settings and Recorded Audio Channels
- Connecting an External Microphone or External Audio Input Source to the Camcorder
- Setting the Audio Input Type for the INPUT 1/INPUT 2 Terminals
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Waveform Monitor
- Adding Marks to Clips while Recording
- Using Metadata
- Recording GPS Information (Geotagging)
- Reviewing a Recording
- Special Recording Modes
- Infrared Recording
- Customization
- Playback
- External Connections
- Network Functions
- Photos
- Additional Information
121
Custom Picture Settings
Custom Picture Settings
The camcorder lets you change many settings (A 124) that control various aspects of the image produced. As
a set, all these settings are treated as a single custom picture file. After adjusting the desired settings to your
preference, you can save up to 20 custom picture files (in the camcorder or on an SD card), and load them later
to apply exactly the same settings (A 123). Only SD card B can be used to save and load custom picture files.
NOTES
• Custom picture files are exclusively compatible for use only with XF705 camcorders.
Selecting Custom Picture Files
Select a custom picture file to apply its settings to your recordings or to edit, rename, protect, or transfer it.
1 Select [Select].
> [/ ! Custom Picture] > [File] > [Select]
2 Select the desired file and then press SET.
• Select one of the custom picture files saved in the camcorder (C1 to C20). To use the settings of a custom
picture file saved on a card, copy the file to the camcorder in advance (A 123).
• When you close the menu, the selected custom picture file’s settings will be applied.
• The icon of the [Gamma] setting in effect will appear on the left of the screen. If the detailed settings were
activated ( > [/ ! Custom Picture] > [Activate Other Settings] is set to [On]), will appear on
the left of the screen.
NOTES
• About changing custom picture related settings using the optional RC-V100 Remote Controller
- When an optional RC-V100 Remote Controller is connected to the camcorder, you can press the remote
controller’s CUSTOM PICT. button to open the [/ ! Custom Picture] menu.
- If a protected custom picture file is selected on the camcorder, custom picture related settings cannot be
changed using the remote controller.
- Adjusting custom picture related settings using the remote controller will change the settings registered
under the currently selected custom picture file. If you want to keep an important custom picture file, copy it
in advance to an SD card or select in advance a custom picture file you do not mind changing.
Editing a Custom Picture File’s Settings
1 Select a custom picture file (A 121).
2 Turn off the preset color settings.
> [/ ! Custom Picture] > [Preset] > [Off]
3 If necessary, change the gamma curve, color space and/or color matrix (A 124).
> [/ ! Custom Picture] > [Gamma], [Color Space], [Color Matrix]
4 Select the desired setting and then press SET.
5 To change the custom picture’s detailed settings, activate the custom picture’s detailed settings.
> [/ ! Custom Picture] > [Activate Other Settings] > [On]
Operating modes: