Owner's Manual

Connecting to a Wi-Fi Network
156
Saving the Configuration
1 Review the access point’s configuration and then press SET.
• Push the joystick left/right to review all the information before pressing SET.
2 Enter a name for the new network configuration profile.
[Input] > Enter the desired name using the keyboard screen (A 27) > [OK]
• If you wish, you can give the network configuration profile a more descriptive name to make it easier to
identify.
3 Select [OK] and then press SET to save the network configuration.
4 When the confirmation screen appears, press SET.
Connecting in Infrastructure Mode
1 Select [Connection Settings].
> [ ! Network Settings] > [Connection Settings]
2 Select the desired network configuration profile and then select [Infrastructure].
Network configuration profile ([1:] to [4:]) > [Edit] > [Infrastructure]
• You can save up to 4 network configuration profiles in the camcorder. Push the joystick up/down to select
the desired profile.
3 Select the desired network setup method and then press SET.
• Continue the setup with the procedure corresponding to the method you wish to use (see the reference
pages below).
[WPS: Button] (A 156)
[WPS: PIN Code] (A 157)
[Search for Access Points] (A 157)
[Manual] (A 158)
Wi-Fi Protected Setup (WPS)
Wi-Fi Protected Setup (WPS) is the easiest way to set up a Wi-Fi access point. You can do simply by pushing a
button (if the access point (wireless router) you want to connect to has a WPS button) or using a PIN code
issued by the camcorder.
Wireless Routers with a WPS Button
1 Press and hold the WPS button on the wireless router.
• The length of time required to hold down the WPS button depends on the wireless router. Refer to the
instruction manual of your wireless router and make sure the wireless router’s WPS function is activated.
2 Within 2 minutes, press SET.
• While [Connecting] appears on the screen, you can press SET to cancel the operation.
3 Continue with the procedure to configure the IP address assignment (A 155).
NOTES
• The [WPS: Button] method may not work correctly if there are several active access points in the area. In such
case try using [WPS: PIN Code] or [Search for Access Points] (A 157) instead.