Owner's Manual
Table Of Contents
- Instruction Manual
- Highlights of the XF705
- Table of Contents
- Introduction
- Preparations
- Recording
- Recording Video
- Video Configuration: Video Format, System Frequency, Frame Rate, Resolution and Bit Rate
- Changing Main Functions with the FUNC Button
- Shutter Speed
- Gain
- ND Filter
- Aperture
- Gamma Curve and Main Color Settings
- White Balance
- Zooming
- Using Optional Conversion Lenses
- Adjusting the Focus
- Image Stabilization
- Onscreen Markers and Zebra Patterns
- Setting the Time Code
- Setting the User Bit
- Synchronizing with an External Device
- Recording Audio
- Audio Settings and Recorded Audio Channels
- Connecting an External Microphone or External Audio Input Source to the Camcorder
- Setting the Audio Input Type for the INPUT 1/INPUT 2 Terminals
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Waveform Monitor
- Adding Marks to Clips while Recording
- Using Metadata
- Recording GPS Information (Geotagging)
- Reviewing a Recording
- Special Recording Modes
- Infrared Recording
- Customization
- Playback
- External Connections
- Network Functions
- Photos
- Additional Information
161
Changing Network Settings
Changing Network Settings
You can check and, if necessary, edit the settings of the currently selected network configuration profile even
after the initial setup. Changing settings manually requires more advanced knowledge of Wi-Fi and network
settings.
1 Select [Connection Settings].
> [ ! Network Settings] > [Connection Settings]
2 Select the network configuration profile you want to check and then press SET.
3 To change the network settings, select [Edit] and then press SET.
4 Select [Infrastructure], [Camera Access Point] or [Ethernet].
• Change the network settings as described in the previous sections.
- Infrastrucure connections (A 156, from step 3)
- Camera Access Point connections (A 155, from step 3)
- Ethernet connections: Connect the network device (step 1, A 159) and change the IP settings (A 155).