Owner's Manual
Table Of Contents
- Instruction Manual
- Highlights of the XF705
- Table of Contents
- Introduction
- Preparations
- Recording
- Recording Video
- Video Configuration: Video Format, System Frequency, Frame Rate, Resolution and Bit Rate
- Changing Main Functions with the FUNC Button
- Shutter Speed
- Gain
- ND Filter
- Aperture
- Gamma Curve and Main Color Settings
- White Balance
- Zooming
- Using Optional Conversion Lenses
- Adjusting the Focus
- Image Stabilization
- Onscreen Markers and Zebra Patterns
- Setting the Time Code
- Setting the User Bit
- Synchronizing with an External Device
- Recording Audio
- Audio Settings and Recorded Audio Channels
- Connecting an External Microphone or External Audio Input Source to the Camcorder
- Setting the Audio Input Type for the INPUT 1/INPUT 2 Terminals
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Waveform Monitor
- Adding Marks to Clips while Recording
- Using Metadata
- Recording GPS Information (Geotagging)
- Reviewing a Recording
- Special Recording Modes
- Infrared Recording
- Customization
- Playback
- External Connections
- Network Functions
- Photos
- Additional Information
167
Browser Remote: Controlling the Camcorder from a Network Device
11 [REC] button
Touch the button to start recording. While recording, the center of the button turns red.
Touch the button again to stop recording.
12 Card selection and approximate remaining recording time
The currently selected SD card is indicated with a
Ð
mark next to the icon.
Remaining recording times are approximate and calculated based on the current video configuration used.
13 [SLOT SELECT] button
Touch the button to select the other SD card when both card slots contain a card.
14 Current camcorder settings
This panel displays an overview of the camcorder settings currently used. You can change camcorder
settings with the controls in the detailed camcorder settings panel (18) on the right.
15 Full auto mode indicator (A 43)
16 Video format (A 50)
17 Time code (same as on the camcorder)
18 Detailed camcorder settings panel (A 167)
Touch one of the tabs at the bottom to select the camcorder settings you wish to adjust:
The Main Remote Recording Screen: Detailed Camcorder Settings
The following sections explain how to use the controls in the detailed camcorder settings panel. For detailed
information and applicable restrictions about the functions themselves, please refer to each function’s
explanation.
To change the white balance
Touch the [White Balance] tab in the detailed camcorder settings panel.
1 Auto white balance button
Touch [ ] to set the camcorder to auto white balance (AWB) mode.
2Custom white balance buttons
Touch [
Å
A] or [
Å
B].
To register a custom white balance
: Point the camcorder at a gray card
or white object with no pattern so it fills the center of the monitoring/live
view screen and touch [
Å
]. Use the same lighting conditions you plan
to use when recording.
During the procedure, the icon in the button will flash quickly. When it
stops flashing, the procedure is completed and the custom white
balance will be applied.
3Preset white balance (¼/É) / Color temperature (È)
Touch a button to apply the corresponding white balance settings as shown in the button.
[ND]: ND filter [WB]: White balance
[Shutter]: Shutter speed [Iris]: Aperture value
[AE]: AE shift [Gain]: Gain value
[White Balance]: White balance mode and related settings.
[Exposure]: Exposure related settings—aperture, shutter speed and gain.
[Focus]: Focus related settings.
[Zoom]: Zoom operation.
1
4
2
3