Owner's Manual
Table Of Contents
- Instruction Manual
- Highlights of the XF705
- Table of Contents
- Introduction
- Preparations
- Recording
- Recording Video
- Video Configuration: Video Format, System Frequency, Frame Rate, Resolution and Bit Rate
- Changing Main Functions with the FUNC Button
- Shutter Speed
- Gain
- ND Filter
- Aperture
- Gamma Curve and Main Color Settings
- White Balance
- Zooming
- Using Optional Conversion Lenses
- Adjusting the Focus
- Image Stabilization
- Onscreen Markers and Zebra Patterns
- Setting the Time Code
- Setting the User Bit
- Synchronizing with an External Device
- Recording Audio
- Audio Settings and Recorded Audio Channels
- Connecting an External Microphone or External Audio Input Source to the Camcorder
- Setting the Audio Input Type for the INPUT 1/INPUT 2 Terminals
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Waveform Monitor
- Adding Marks to Clips while Recording
- Using Metadata
- Recording GPS Information (Geotagging)
- Reviewing a Recording
- Special Recording Modes
- Infrared Recording
- Customization
- Playback
- External Connections
- Network Functions
- Photos
- Additional Information
177
FTP File Transfer
Transferring Clips (FTP Transfer)
Transferring a Single Clip
1 Select the desired network (A 160).
• Use an Infrastructure connection (A 154) or Ethernet connection (A 159).
• With Ethernet connections, connect the camcorder to the desired network using an Ethernet cable.
2 Select the desired clip and then press SET to open the clip menu.
3 Select [FTP Transfer] and then press SET.
4 Select [OK] and then press SET.
• The camcorder will connect to the FTP server and the selected clip will be transferred. When using an
Ethernet connection, the Ethernet access lamp will flash while files are transmitted.
• Press the CANCEL button to cancel the operation.
5 When the confirmation message appears, press SET.
Transferring All the Clips
1 Open the index screen with the clips you want to transfer (A 131).
2 Select the desired network (A 160).
• Use an Infrastructure connection (A 154) or Ethernet connection (A 159).
• With Ethernet connections, connect the camcorder to the desired network using an Ethernet cable.
3 Select [FTP Transfer].
[ ! Network Settings] > [FTP Transfer]
4 Select [OK] and then press SET.
• The camcorder will connect to the FTP server and all the clips in the index screen will be transferred. When
using an Ethernet connection, the Ethernet access lamp will flash while files are transmitted.
• Press the CANCEL button to cancel the operation.
5 When the confirmation message appears, press SET.
IMPORTANT
• Observe the following precautions when transferring files. Failing to do so may interrupt the transfer and
incomplete files may remain at the transfer destination.
- Do not open the card slot covers.
- Do not disconnect the power source or turn off the camcorder.
• If incomplete files remain at the transfer destination, check the content and make sure they are safe to delete
before deleting them.
NOTES
• Depending on the access point’s settings and capabilities, it may take some time to transfer files.