Owner's Manual
Table Of Contents
- Instruction Manual
- Highlights of the XF705
- Table of Contents
- Introduction
- Preparations
- Recording
- Recording Video
- Video Configuration: Video Format, System Frequency, Frame Rate, Resolution and Bit Rate
- Changing Main Functions with the FUNC Button
- Shutter Speed
- Gain
- ND Filter
- Aperture
- Gamma Curve and Main Color Settings
- White Balance
- Zooming
- Using Optional Conversion Lenses
- Adjusting the Focus
- Image Stabilization
- Onscreen Markers and Zebra Patterns
- Setting the Time Code
- Setting the User Bit
- Synchronizing with an External Device
- Recording Audio
- Audio Settings and Recorded Audio Channels
- Connecting an External Microphone or External Audio Input Source to the Camcorder
- Setting the Audio Input Type for the INPUT 1/INPUT 2 Terminals
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Waveform Monitor
- Adding Marks to Clips while Recording
- Using Metadata
- Recording GPS Information (Geotagging)
- Reviewing a Recording
- Special Recording Modes
- Infrared Recording
- Customization
- Playback
- External Connections
- Network Functions
- Photos
- Additional Information
23
Date, Time and Language Settings
Date, Time and Language Settings
Setting the Date and Time
You will need to set the date and time on the camcorder before you can start using it. When the internal clock is
not set, or if the settings were lost because the built-in backup battery is depleted, the [Date/Time] screen will
appear automatically with the time zone selected when you turn on the camcorder.
1Push the joystick up/down to select the desired time zone and then press SET (press the joystick
itself) to move to the next field.
• To move between fields you can also push the joystick left/right.
• The default time zone is [UTC-05:00] (New York) or [UTC+01:00] (Central Europe), depending on the
country/region of purchase. Time zones are based on Coordinated Universal Time (UTC).
2 Change the rest of the fields in the same way.
3 Select [Set] and then press SET to start the clock and close the screen.
NOTES
• You can display the date/time in mode with the > [
¢%
Monitoring Setup] > [Custom
Display 2] > [Date/Time] setting.
• After the initial setup, you can change the time zone, date and time with the > [B ! System Setup]
> [Time Zone] and [Date/Time] settings. You can also change the date format and clock format (12 or 24
hours) with the > [B ! System Setup] > [Date Format] setting.
• When the built-in backup battery is exhausted, the date and time setting may be lost. In such case, recharge
the built-in backup battery (
A 216) and set the time zone, date and time again.
• Using the optional GP-E2 GPS Receiver, you can have the camcorder adjust settings automatically according
to the UTC date/time information received from the GPS signal (A 110).
Operating modes: