Owner's Manual
Table Of Contents
- Instruction Manual
- Highlights of the XF705
- Table of Contents
- Introduction
- Preparations
- Recording
- Recording Video
- Video Configuration: Video Format, System Frequency, Frame Rate, Resolution and Bit Rate
- Changing Main Functions with the FUNC Button
- Shutter Speed
- Gain
- ND Filter
- Aperture
- Gamma Curve and Main Color Settings
- White Balance
- Zooming
- Using Optional Conversion Lenses
- Adjusting the Focus
- Image Stabilization
- Onscreen Markers and Zebra Patterns
- Setting the Time Code
- Setting the User Bit
- Synchronizing with an External Device
- Recording Audio
- Audio Settings and Recorded Audio Channels
- Connecting an External Microphone or External Audio Input Source to the Camcorder
- Setting the Audio Input Type for the INPUT 1/INPUT 2 Terminals
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Waveform Monitor
- Adding Marks to Clips while Recording
- Using Metadata
- Recording GPS Information (Geotagging)
- Reviewing a Recording
- Special Recording Modes
- Infrared Recording
- Customization
- Playback
- External Connections
- Network Functions
- Photos
- Additional Information
39
Using the Optional RC-V100 Remote Controller
Using the Optional RC-V100 Remote Controller
You can connect the optional RC-V100 Remote Controller to the camcorder’s REMOTE A terminal or REMOTE
B terminal in order to control the camcorder (including advanced recording functions) from a distance. The
remote controller lets you turn on the camcorder, navigate the menus and change settings, control the aperture
and shutter speed, change some custom picture settings, and more. When you use the REMOTE B terminal to
connect the RC-V100, the camcorder can receive and process multiple simultaneous commands from the
remote controller.
For details on how to connect and use the remote controller, refer to its instruction manual.
1 Turn off the camcorder and connect the optional RC-V100 Remote Controller to the camcorder.
• Make sure that the remote controller’s terminal selection switch is set to match the terminal to be used on
the camcorder.
2 Turn on the camcorder and select [REMOTE Term.].
> [B $ System Setup] > [REMOTE Term.]
3 Select [RC-V100 (REMOTE A)] or [RC-V100 (REMOTE B)] depending on the terminal used and then
press SET.
Options
[RC-V100 (REMOTE A)], [RC-V100 (REMOTE B)]:
Select this option to use the optional RC-V100 Remote Controller connected to the
corresponding REMOTE terminal.
[Standard]: Select this option to use commercially available remote controls.
NOTES
• When the camcorder is set to full auto mode (A 43), settings related to the aperture, gain, shutter speed and
white balance (except for [R Gain] and [B Gain] in the custom picture's [White Balance] settings*) cannot be
changed using the remote controller.
* When infrared recording is activated, even the WHITE BALANCE R and B dials will have no effect on the camcorder.
• Adjusting picture-related settings with the remote controller can be performed only when the detailed settings
were activated ( > [/ ! Custom Picture] > [Activate Other Settings] is set to [On], A 121).
Operating modes:
RR-10 or RR-100 8-pin
Remote Cable (optional)
To the RC-V100’s
REMOTE A terminal
To the RC-V100’s
REMOTE B terminal
Remote cable
(supplied with the RC-V100)