Owner's Manual
Table Of Contents
- Instruction Manual
- Highlights of the XF705
- Table of Contents
- Introduction
- Preparations
- Recording
- Recording Video
- Video Configuration: Video Format, System Frequency, Frame Rate, Resolution and Bit Rate
- Changing Main Functions with the FUNC Button
- Shutter Speed
- Gain
- ND Filter
- Aperture
- Gamma Curve and Main Color Settings
- White Balance
- Zooming
- Using Optional Conversion Lenses
- Adjusting the Focus
- Image Stabilization
- Onscreen Markers and Zebra Patterns
- Setting the Time Code
- Setting the User Bit
- Synchronizing with an External Device
- Recording Audio
- Audio Settings and Recorded Audio Channels
- Connecting an External Microphone or External Audio Input Source to the Camcorder
- Setting the Audio Input Type for the INPUT 1/INPUT 2 Terminals
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Waveform Monitor
- Adding Marks to Clips while Recording
- Using Metadata
- Recording GPS Information (Geotagging)
- Reviewing a Recording
- Special Recording Modes
- Infrared Recording
- Customization
- Playback
- External Connections
- Network Functions
- Photos
- Additional Information
49
Recording Video
To set the reel number or initial clip number
The initial clip number can only be set when [Clip Numbering] is set to [Continuous].
1 Select [Reel Number] or [Clip Number].
> [
Æ
" Recording/Media Setup] > [Metadata] > [Reel Number] or [Clip Number]
2 Select [Change] and then press SET.
• To reset the reel/clip number to [001], select [Reset] instead.
3 Push the joystick up/down to select the first digit of the reel/clip number and then press SET to move to the
next.
• Change the rest of the digits in the same way.
4 Select [Set] and then press SET.
To set the user-defined field
1 Select [User Defined].
> [
Æ
" Recording/Media Setup] > [Metadata] > [User Defined]
2 Select [Change] and then press SET.
• To reset the user-defined field to [CANON], select [Reset] instead.
3 Push the joystick up/down to select the first character and then press SET to move to the next.
• Change the rest of the characters in the same way.
4 Select [Set] and then press SET.
Using the Fan
The camcorder uses an internal cooling fan to reduce the camcorder’s internal heat. You can change the fan’s
operation mode.
1 Select [Fan].
> [
B
% System Setup] > [Fan]
2 Select the desired option and then press SET.
Options
[Automatic]: The fan runs while the camcorder is not recording and is automatically turned off while the
camcorder is recording. However, if the internal temperature of the camcorder is too high (
b
appears in red), the fan will be activated automatically (in that case,
`
will appear next to the
b
icon). When the camcorder’s temperature has decreased sufficiently, the fan will be turned
off. Use this setting when you do not want the camcorder to pick up the fan’s operating sound.
[Always On]: The fan runs at all times.
IMPORTANT
• While the fan is running, the exhaust vent will emit warm air.
• Be careful not to obstruct in any way the fan’s air vents (A 11, 13, 16).
NOTES
NOTES
• Depending on the ambient temperature and other shooting conditions, the fan may not turn off even if you set
its operating mode to [Automatic].
• In mode the fan runs at all times.
Operating modes: