Owner's Manual
Table Of Contents
- Instruction Manual
- Highlights of the XF705
- Table of Contents
- Introduction
- Preparations
- Recording
- Recording Video
- Video Configuration: Video Format, System Frequency, Frame Rate, Resolution and Bit Rate
- Changing Main Functions with the FUNC Button
- Shutter Speed
- Gain
- ND Filter
- Aperture
- Gamma Curve and Main Color Settings
- White Balance
- Zooming
- Using Optional Conversion Lenses
- Adjusting the Focus
- Image Stabilization
- Onscreen Markers and Zebra Patterns
- Setting the Time Code
- Setting the User Bit
- Synchronizing with an External Device
- Recording Audio
- Audio Settings and Recorded Audio Channels
- Connecting an External Microphone or External Audio Input Source to the Camcorder
- Setting the Audio Input Type for the INPUT 1/INPUT 2 Terminals
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Waveform Monitor
- Adding Marks to Clips while Recording
- Using Metadata
- Recording GPS Information (Geotagging)
- Reviewing a Recording
- Special Recording Modes
- Infrared Recording
- Customization
- Playback
- External Connections
- Network Functions
- Photos
- Additional Information
91
Setting the User Bit
Setting the User Bit
The user bit display can be selected from the date or the time of recording, or an identification code consisting of
8 characters in the hexadecimal system. There are sixteen possible characters: the numbers 0 to 9 and the
letters A to F.
The user bit is recorded with clips and can be output from the TIME CODE terminal, SDI terminal or HDMI OUT
terminal. It can be used freely to categorize and manage recordings or to keep additional information about
them.
Setting an Hexadecimal Code
1 Open the user bit setting screen.
> [
B
# System Setup] > [User Bit Type] > [Setting] > [Change]
• The user bit setting screen appears with an orange selection frame on the leftmost character.
• To reset the user bit to [00 00 00 00], select [Reset] instead.
2 Push the joystick up/down to select the first character and press SET to move to the next.
• Change the rest of the characters in the same way.
• Press the CANCEL button to return to the previous screen without setting the user bit.
3 Select [Set] and press SET.
Using the Date or Time
1 Select [User Bit Type].
> [B # System Setup] > [User Bit Type]
2 Select [Date] or [Time] and then press SET.
Operating modes: