User's Manual

6.
Complete the setup
Click OK.
When printing is executed, a drapery or banner can be printed according to the roll.
Enlarge and print
1.
Register user-defined paper
Register both the actual desired print size (user-defined paper 1) and original document size created
in application (user-defined document size 2) in the Size Options... under the Page Setup tab.
Note
• Please set user-defined paper 2 to the same aspect ratio as user-defined paper 1. If the aspect
ratio differs, the enlarged image may not turn out to be the expected size.
After creating user-defined paper 1, if user-defined paper 2 is created after checking Fix the
Ratio of the Width to Height, settings can be set to the same aspect ratio.
Also set user-defined paper 2 to a size that doesn't exceed the maximum size supported by the
application.
For example, when printing on paper 600mm wide and 3,000mm long, use the following
settings.
(when setting length to 1/6 the user-defined paper)
•
User-defined paper 1: Width600mm, Height3,000mm
•
User-defined paper 2: Width100mm, Height500mm
2. Create original document in application software
Use registered user-defined paper 2 to create original document in application software.
3. Open printer driver settings screen
571