User's Manual
Cut to standard size
Specifies standard size as the output page size when printing on roll paper.
This setting item is displayed by tapping in the following order.
(Setup) > Device settings > Print settings > HP-GL/2 print settings > Paper settings
• ON
Cuts to standard size in accordance with the roll paper width.
When there are two lengths/widths applicable for a given roll paper width, the optimum size is selected
automatically.
Note
• If ON is selected for Conserve paper and there is blank space above/below the image, the size will
not be standard size.
• When ON is selected for Print centered, printing will be in the center of the standard size.
• If there is no standard size corresponding to the roll paper width, operation is the same as if OFF is
selected. No message is displayed.
• For information about supported standard sizes, see Standard Size Table.
• OFF (Initial setting)
Cutting according to standard size is not performed.
STANDARD CUT EXAMPLES
• A3-size width roll paper
A. Position of cut when OFF
B. Position of cut when ON
• A3-size width roll paper
189