User Guide

496
Wi-Fi Connection via Access Points
This section describes how to join a Wi-Fi network via an access point.
Checking the Type of Access Point
Determine whether the access point for the Wi-Fi connection is
compatible with WPS (Wi-Fi Protected Setup), as described in the
access point instruction manual or other documentation.
z
When WPS is supported
The following two Wi-Fi connection methods are available.
Connection can be established easier with WPS (PBC mode).
WPS (PBC mode):
Follow the steps beginning on page 497.
WPS (PIN mode):
Follow the steps beginning on page 501.
z
When WPS is not supported
Follow the steps beginning on page 504. In this case, access point
encryption must be set to one of the following.
[Authentication]:
Open system, Shared key, or WPA/WPA2-PSK
[Encryption settings]:
WEP, TKIP, or AES
o
If stealth functions of the access point are active, Wi-Fi connection
may be disabled. Deactivate stealth functions.
o
When connecting to a network that has a network administrator, ask the
administrator about the detailed setting procedures.
If the network you use lters by MAC address, register the MAC address of
the camera at the access point. The MAC address can be checked on the
[View info] screen (p.516).