Owner's Manual

104
Auto Correction of Brightness and Contrast
N
If the image comes out dark or the contrast is low, the brightness and
contrast can be corrected automatically. This function is called Auto
Lighting Optimizer. The default setting is [Standard].
In [
A
] mode, [Standard] is set automatically.
1
Select [
z
3: Auto Lighting
Optimizer].
2
Set a correction option.
z
Select an option, then press <
0
>.
3
Take the picture.
g
The image will be recorded with the
brightness and contrast corrected as
necessary.
o
Noise may increase and sharpness may change, under some shooting
conditions.
o
If the e󰀨ect of Auto Lighting Optimizer is too strong and results are not at
your preferred brightness, set to [Low] or [Disable].
o
If a setting other than [Disable] is set and you use exposure
compensation or ash exposure compensation to darken the exposure,
the image may still come out bright. If you want a darker exposure, set
this function to [Disable].
o
Maximum burst is lower with [High]. Image recording to the card also
takes longer.
In step 2, if you press the <
B
> button and remove the checkmark
[
X
] for [Disabled in M or B modes] setting, the [
z
3: Auto Lighting
Optimizer] can also be set even in [
a
] and [BULB] modes.
0 . y " •
J '
Expo comp /AEB 3 2 1 ~ 1 2 •3
01 S0 speed settings
Auto Lig hting Opt1m 1z er ~J
Highlight tone priority OFF
Metering timer 8 sec
Expo s1mula t 1on Enable
Auto Lighting OptIm Izer
Standard
~F ~u ~ ~1
Imm ✓ Disabled in M or B modes
&llll OK
-