Installation guide

Setting Up a Computer as a File Server
6-7
6
Using a NetWare Network (Windows)
Setting Up a Computer as a File Server
To send data from the machine to a computer on your network, you need to specify the settings of
the computer for receiving data.
This section describes how to set up a computer as a file server.
Optional equipment is required to send data if you are using the imageRUNNER 3245/3235/3230/3225. For the
equipment needed, see “Optional Equipment and System Requirements for Connecting to a Network,” on p. 3-2.)
To send a file to the NetWare server, specify the following NetWare settings for the machine. For instructions on how
to specify the protocol settings, see “Protocol Settings,” on p. 6-3.
<NetWare>: [On]
<Frame Type>: Frame type suitable for your environment
This section describes only the procedures for setting up a computer receiving data sent from the machine. To send
data from the machine to a server on the network, you must enter an address setting from the control panel. For
instructions on how to specify recipient address settings, see e-Manual > Send/Fax.
In some environments, additional detailed settings, such as authority settings, may be required. For details, consult
the network administrator of the environment you are using.
1 Log in to NetWare as Administrator (or as a user of equivalent authority) →
set up the users and passwords for sending data from the machine.
Enter a user name, and a password not longer than 24 alphanumeric characters.
2 Create a directory to be used for recipient addresses, and then enable read
access and write access by the users who will be sending data.
•
•
-
-
•
•