Installation guide

NetBIOS Network Setup Procedures
7-2
7
Using a NetBIOS Network
NetBIOS Network Setup Procedures
To use a NetBIOS network, it is necessary to perform the following procedures.
1
Protocol Settings (See “Protocol Settings,” on p. 7-3.)
Specify the protocol settings. To specify the settings, use:
The machine's control panel
The Remote UI (via a web browser)lit.
•
•
2
Computer Settings for Printing/Sending a Fax (See e-Manual > Network)
Specify the settings of each computer you use for printing or sending a fax. (Optional equipment is required to print or send a fax from a
computer. For the equipment needed, see “Optional Equipment and System Requirements for Connecting to a Network,” on p. 3-2.)
3
Computer Settings for a File Server (See “Setting Up a Computer as a File Server,” on p. 7-6.)
Specify the settings of the computer receiving data sent from the machine. (Optional equipment is required to send data if you are using
the imageRUNNER 3245/3235/3230/3225. For the equipment needed, see “Optional Equipment and System Requirements for Connecting
to a Network,” on p. 3-2.)
It is recommended that steps 1 and 3 above be performed by the network administrator.
The only base protocol supported by the machine for NetBIOS networks is TCP/IPv4. TCP/IPv6 and NetBEUI are not
supported (SMB is used as a print application).
•
•