Installation guide

Settings Required Prior to Remote Scanning
12-5
12
Before Using the Remote Scan Function
Settings Required Prior to Remote Scanning
Once you have installed the scanner driver, the following settings are required in order to perform
remote scanning.
For details about this procedure, see e-Manual > Software or the online help.
Switching the Scanner Online and Offline
In order to start the scanner driver and scan, the scanner must be set to [Online] beforehand at the device.
When the scanner is online, communication with devices connected over a network is possible and the
scanner can receive data from computers.
Selecting the Network Scanner You Want to Use
In order to scan using Network ScanGear or Color Network ScanGear, select the device on the network that
you want to use as a scanner using the ScanGear Tool. Because a scanner is not selected immediately after
installation, this operation must be performed before use.
The ScanGear Tool is software that is installed together Network ScanGear/Color Network ScanGear.
■
■