Owner's Manual
Table Of Contents
56
Flash Firing Restrictions due to
Temperature Increase
When continuous ash or modeling ash is repeatedly red in short
intervals, the temperature of the ash head, batteries, and the area
near the battery compartment may increase.
Repeated ash ring gradually increases the ring interval to
avoid wearing out or damaging the ash head from overheating.
Continuing to re the ash in this state will automatically restrict
ash ring.
Flash Firing Restriction
As the internal temperature rises, the ring interval increases to approx.
10 sec. Continuing to re the ash further increases the ash ring
interval to approx. 45 sec.
Stop using the ash for at least 40 min. when ring is restricted.
Continuous Flash Count and Rest Time
Stop using the ash for at least 40 min. after ring it at full output more than
30 times repeatedly or using modeling ash repeatedly more than 30 times.
CAUTION
When performing continuous ash, do not touch the ash head,
batteries, or the area near the battery compartment.
When continuous ash or modeling ash is repeatedly red at short intervals, do
not touch the ash head, batteries, or the area near the battery compartment.
The ash head, batteries, and area near the battery compartment may
become hot, resulting in the risk of burn.
o
Do not open or close the ash battery compartment cover while ash ring
is restricted. Doing so is very dangerous since the ash ring restriction is
canceled.
o
If ash photography is performed in high temperatures, the ring restrictions
may be activated before the number of ashes listed above is red.
o
For cautions on the number of ash rings, see page 11 (continuous
ashes) or page 23 (modeling ash).
o
The Speedlite may not re in rare cases due to environmental factors
such as temperature rise.