Owner's Manual

600
Troubleshooting Guide
Even after I change the card, the maximum burst displayed for
continuous shooting does not change.

The maximum burst displayed does not change when you switch cards,
even if you switch to a high-speed card. The maximum burst shown in
the table on
=
615 is based on Canon’s testing card. (The faster the
card’s writing speed, the higher the actual maximum burst will be.) For
this reason, the maximum burst displayed may diff er from the actual
maximum burst.
Even if I set a decreased exposure compensation, the image
comes out bright.

Set [
z
: Auto Lighting Optimizer] to [Disable] (
=
218). When [Low],
[Standard], or [High] is set, even if you set a decreased exposure
compensation or fl ash exposure compensation, the image may come out
bright.
I cannot set the exposure compensation when both manual
exposure and ISO Auto are set.

See
=
118 to set the exposure compensation.
Not all the lens aberration correction options are displayed.

Although [Chromatic aberr corr] and [Diff raction correction] are
not displayed when [Digital Lens Optimizer] is set to [Enable], both
functions are applied in shooting, as when set to [Enable].

During movie recording, [Digital Lens Optimizer], [Diff raction
correction], or [Distortion correction] will not be displayed.
The built-in fl ash does not fi re.

Shooting with the fl ash may be temporarily disabled to protect the fl ash
head if the built-in fl ash is used repeatedly over a short period.